Cleaning And Storage; Maintenance - Comet CBM Serie Anleitungen Für Montage, Gebrauch Und Wartung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

2. Switch off the CBM module using the I/O switch (1).

3. Wait until the motor pump and the machine incorporating it have cooled down.

4. If the machine is not to be used for some time, disconnect the battery cables.

CAUTION

• When the CBM module and the machine that incorporates it are left to cool ensure:

- it is not left unattended if there are unsupervised children, elderly or disabled persons present;

- it is stable with no risk of falling;

- it is not in contact with, or in the immediate vicinity of, flammable materials.

CAUTION

• Pay particular attention to the information in the section

• All cleaning must be carried out only after the procedures described in the section

i.e. with no parts in motion, with no hoses containing liquid under pressure and when cooling is

complete.

In particular, always remember to disconnect the battery.

• All cleaning procedures must be carried out in conditions of stability.

• Do not use thinners or solvents for cleaning.

WARNING

• Before cleaning and storage of the CBM module remember to run the EVERFLO motor pump for a few

minutes with pure water to clean the hoses and internal parts to remove the chemicals used.

• Never store leave the EVERFLO motor pump with chemicals inside it.

• The EVERFLO motor pump is subject to frost damage.

In order to prevent the formation of ice inside the machine in harsh environments, it is advisable

to aspirate an automotive antifreeze and then proceed to completely evacuate it before storing

the machine. If it is not possible to protect the motor pump as outlined above, place it in a warm

environment before start-up for a period of time that is sufficient for any ice that may have formed

inside it to melt – failure to comply with these simple requirements may result in serious damage to

the motor pump.

CAUTION

• Fluids used for rinsing and antifreeze must be properly disposed of and not dispersed in the

environment.

CAUTION

• Follow the maintenance instructions contained in the manual of the machine that

incorporates the CBM module and the EVERFLO motor pump that includes it.

• Maintenance must be carried out only after the procedures described in the section

i.e. with no parts in motion, with no hoses containing liquid under pressure and when cooling is

complete.

in particular, always remember to disconnect the battery.

• All maintenance must be carried out in conditions of stability.

• CAUTION. To ensure the safety of the CBM module, only original spare parts supplied by the

Manufacturer or approved thereby must be used.