Battery Installation And Charging - Comet CBM Serie Anleitungen Für Montage, Gebrauch Und Wartung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

CAUTION

• Depending on the CBM module that is in use, install the corresponding battery type, referring to

the section

peCiFiCations anD teChniCal Data

• Observe the connection instructions in the section

diagram shown in figure 6.

Connecting the battery

The battery (optional or supplied, depending on the CBM module purchased) must be assembled as

follows:

- Remove the protective cover (7) by unscrewing the securing screws;

- insert the battery (10) inside the CBM module securing it with the support bracket (8), for smaller

batteries, reduction bracket (9) can also be used;

- connect the cables to the battery (proceed in the following order observing the polarities):

- screw the cable lug of the red cable to the positive (+) pole of the battery;

- screw the lug of the black cable to the negative (-) pole of the battery;

- refit the protective cover (7).

Recharging the battery

Recharging must be carried out with the cables inside the CBM module connected to the battery and

with the switch (1) in the OFF position

Recharge the battery using the battery charger (12) and the supplied connecting cables (11) and (13):

- connect the power cable (11) to the mains and to the battery charger (12)

- insert the plug of the charging cable (13) to the socket (5) on the CBM module

Charge by following the instructions in the charger booklet inside the package.

Disconnecting the battery

- remove the protective cover (7) by unscrewing the securing screws

- disconnect the cables from the battery (proceed in the following order):

- disconnect the black cable from the negative (-) pole of the battery;

- disconnect the red cable from the positive (+) pole of the battery;

- refit the protective cover (7)

CAUTION

• Observe the connection instructions in the section

• Suction lines must have a nominal pressure of 5 bar (73 psi).

• The delivery hoses must have a nominal pressure not lower than the maximum pressure of the motor

pump.

• Do not tighten suction or delivery fittings with torques exceeding 5 Nm (45 lbf in).

• All hoses must be securely fastened with clamps to their respective fittings.

For the hydraulic suction and delivery fittings, refer to the following table and to Fig. 5, where a schematic

diagram of possible machine including the motor pump is shown.