Blaupunkt HOR301 Bedienungsanleitung Seite 9

HOR301 / HOR401 / HOR501
TECHNICAL DATA
Model/Parameter HOR301
Power supply 220-240V~50Hz
Power 1500W
A - Radiator fins
B - Handle
C - Thermostat knob
D - Power-switch knob
BEFORE THE FIRST USE
Fix the castors to the bottom part of the radiator according to the diagram in the Figure. Figure 5
applies to model HOR301 only.
1. Turn the radiator upside down.
2. Fit the flat components holding the castors
3. Put the "U"-shaped metal part through the radiator and insert its ends into the flat component.
Screw down with the wing nuts.
4. Place the radiator on a level, stable, and heat-resistant surface.
USING THE APPLIANCE
1. Make sure that the appliance's power switch is set to the "0" position, and the thermostat is set to the
minimum value. Connect the plug to the power source.
2. Set the switch from the "0" position to "
power), or " " (maximum heating power).
3. Turn the thermostat knob clockwise to the maximum position. When the room temperature rises to a
comfortable level, slowly rotate the thermostat counter-clockwise until the status lamp goes out. Turn
the thermostat knob clockwise to increase the required temperature. In order to decrease the
temperature, turn the knob counter-clockwise. The radiator will try to maintain the set room
temperature by switching on and off.
4. To switch off the radiator, set the power switch to the "0" position and the thermostat knob to the
minimum position. Disconnect the product from the mains.
Overturning protection
The radiator is protected by a safety switch, which automatically switches off the appliance if the
heater overturns, or is at too acute an angle to the horizontal. This helps prevent accidents, and the
radiator will resume its operation when it is put back on.
OVERHEATING PROTECTION
The radiator is protected with overheating protection which automatically switches off the appliance
if it intensely overheats. In that event, disconnect the appliance from the mains, wait approx. 30
minutes for the radiator to cool down, and rectify any possible cause of the overheating, e.g.,
something covering the radiator. Check the appliance, cable, and plug for damage. If no damage is
observed, reconnect the appliance and switch it on, according to the manual. If the radiator does not
switch on, contact the customer service for assistance.
CLEANING AND MAINTENANCE
During use, clean the appliance regularly according to the following instructions.
1. Disconnect the appliance from the power source, and let it cool down before cleaning.
2. Gently clean the appliance's external surface and control panel with a damp and lint-free cloth.
HOR401 HOR501
2000W 2500W
E - Cable reel
F - Flat castor-fixing components
G - Castors
" (minimum heating power), "
7
" (medium heating