Cleaning Filters; Carbon Filter - Atag CU90511RM Anleitung

USE

Cleaning filters

EN 10
Changing the colour lighting temperature
You can adjust the lighting temperature.
• Press and hold the light key for 1 second.
The light switches on at maximum strength.
• Press the 'C' key to make the light 'colder' or press the 'W' key to
make the light 'warmer'.
Saturation of grease and carbon filters
The filters should be replaced or cleaned when the filter indicator is lit.
See 'Maintenance' chapter.
Grease filter
The filter indicator will light up after 30 operating hours.
• The grease filters should then be cleaned.
• Reset the memory by pressing and holding the '-' key until the filter
indicator stops flashing.

Carbon filter

The filter indicator will flash after 120 operating hours.
• The carbon filter should then be cleaned or replaced.
• Reset the memory by pressing and holding the '-' key until the filter
indicator stops flashing.