Makita DHR280 Betriebsanleitung Seite 25

NOTE: The wireless activation lamps finish blinking in green
after 20 seconds elapsed. Press the wireless activation button
on the tool while the wireless activation lamp on the cleaner is
blinking. If the wireless activation lamp does not blink in green,
push the wireless activation button briefly and hold it down
again.
NOTE: When performing two or more tool registrations for one
vacuum cleaner, finish the tool registration one by one.
Starting the wireless activation function
NOTE: Finish the tool registration for the vacuum cleaner prior
to the wireless activation.
4. Push the wireless activation button on the tool
briefly. The wireless activation lamp will blink in blue.
► Fig.49:
1. Wireless activation button 2. Wireless
activation lamp
5. Pull the switch trigger of the tool. Check if the
vacuum cleaner runs while the switch trigger is being pulled.
To stop the wireless activation of the vacuum cleaner, push
the wireless activation button on the tool.
Description of the wireless activation
lamp status
► Fig.50:
1. Wireless activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the table below for the
meaning of the lamp status.
Status
Color
Standby Blue
Tool Green
registration
Cancelling Red
tool
registration
Wireless activation lamp
On Blinking
After registering a tool to the vacuum
cleaner, the vacuum cleaner will
automatically runs along with the switch
operation of the tool. 1.
the wireless unit to the tool.
2.
cleaner with the tool.
► Fig.47
3.
vacuum cleaner to "AUTO".
► Fig.48:
NOTE: The wireless activation lamp on the tool will
stop blinking in blue when there is no operation for 2
hours. In this case, set the stand-by switch on the
vacuum cleaner to "AUTO" and push the wireless
activation button on the tool again.
NOTE: The vacuum cleaner starts/stops with a delay.
There is a time lag when the vacuum cleaner detects
a switch operation of the tool.
NOTE: The transmission distance of the wireless unit
may vary depending on the location and surrounding
circumstances.
NOTE: When two or more tools are registered to one
vacuum cleaner, the vacuum cleaner may start
running even if you don't pull the switch trigger
because an other user is using the wireless activation
function.
Duration
2 hours The wireless activation of the vacuum cleaner is available. The
lamp will automatically turn off when no operation is performed for
2 hours.
When The wireless activation of the vacuum cleaner is available and the
the tool is tool is running.
running.
20 seconds Ready for the tool registration. Waiting for the registration by the
vacuum cleaner.
2 seconds The tool registration has been finished. The wireless activation
lamp will start blinking in blue.
20 seconds Ready for the cancellation of the tool registration. Waiting for the
cancellation by the vacuum cleaner.
2 seconds The cancellation of the tool registration has been finished. The
wireless activation lamp will start blinking in blue.
25 ENGLISH
NOTE: Refer to the instruction manual of
the vacuum cleaner, too.
Connect the hose of the vacuum
Set the stand-by switch on the
1. Stand-by switch
Description
Install