Startup Procedure - Weidmuller 8808420000 Bedienungsanleitung

4.

Startup Procedure

Before operation put in the 9 V block battery first.
1. Unscrew the two screws on the bottom of the unit and take this part away. You will find the battery
case with the connector clip for the battery.
2. Press the clip on to the battery and put the battery into the battery case. Should the battery be
contacted with the wrong polarity the IE-CT will not be damaged.
3. Close the lid and fasten the screws.
Now the installation tester IE-CT is ready for use!
First do two test runs to get familiar with the functions of the IE-CT:
1. Turn on the IE-CT Mainframe with the Start Key (D). Now a test starts automatically (it takes
about 3 s). The green LED (G) will flash. When the test is finished the numeric display of the IE-CT
Mainframe shows as test result the digit "2" (B). Digit "2" means connection error – the IE-CT could
neither detect a connection among conductors (short circuit) nor a connection to the IE-CT Test
Box.
After approx. 30 s the IE-CT Mainframe shuts off automatically or you turn it off by pressing the Start
Key (D).
2. Now plug the attachment cord (J) of the IE-CT Test Box into the RJ45 jack of the IE-CT Mainframe
(E) and start the test again by pressing the Start Key (D). When the test is finished the green LED
(G) lights continuously, this means the test was successfully finished and no errors were found.
Now press the Step Key (H), the numeric display (B) of the IE-CT Mainframe will show the number
of the connected IE-CT Test Box by a flashing digit (flashing digit "1" means "IE-CT Test Box No 1"
is connected).
After 30 s the IE-CT Mainframe shuts off automatically or it can be turned off by pressing the Start Key
(D).
Unplug the IE-CT Test Box attachment cord of the RJ45 jack (E) of the IE-CT Mainframe and plug it in
the enclosed attachment cord (A).
Now you can start testing your installation or cable. The following sections will give you more detailed
information about connection and use of the IE-CT.
18