Foreword - AWG M0,4 Originalbetriebsanleitung

AWG I Operating manual I Fittings I

FOREWORD

Applicable standards and regulations
The design and construction of the AWG Medium expansion foam pis-
tol M0,4 was carried out in accordance with the relevant provisions laid
down by these directives and the harmonised standards:
DIN EN 16712-3:2015
Portable equipment for projecting extinguishing agents supplied by
fire fighting pumps – Part 3: Low and medium expansion hand-held
foam branchpipes PN 16
Conversions and modifications
Unauthorised conversions or modifications to the Medium expansion
foam pistol M0,4 are prohibited without written consent from the manu-
facturer .
AWG Fittings GmbH accepts no liability for damage caused by conver-
sions or modifications, improper handling by the customer or by third
parties commissioned by the customer, or caused by non-compliance
with these instructions.
Applicable Documents
Apart from this manual, no other applicable documents are required for
the safe handling of the AWG Medium expansion foam pistol M0,4.
The data sheet for this device can be downloaded for information pur-
poses from the Internet: www.awg-fittings.com
Copyright
This operating manual is valid for the device
AWG Medium expansion foam pistol M0,4
© AWG Fittings GmbH Revision: 02 of 18/03/2020
All rights to this document are reserved by AWG Fittings GmbH.
The document may not be copied or reproduced in whole or in part
without the written permission of AWG Fittings GmbH. The document
is intended for persons using the device described and must not be
passed on to third parties.
Subject to technical changes and errors.
These instructions and the applicable documents are not subject to
any automatic update service. The latest version can be obtained from
the manufacturer.
M1037B01 I Rev. 02-03/20
Medium expansion foam pistol M0,4
ENGLISH
FOREWORD
21 / 40