Philips 32PF4320 Bedienungsanleitung Seite 13

Tips Tips
Poor Picture • Have you selected the correct TV system in the manual installation menu?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio
• Mountains or high buildings can cause double pictures or ghost images.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
No Picture • Are the supplied cables connected properly ? (The aerial cable to the TV, the
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the TV lights up green,
• In case of weak or bad signal, consult your dealer.
Digital distortion The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Smart picture key ≈ on
the remote control.
No sound • No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key ¬?
Switch your TV off and then on again once. Never attempt to repair a defective
No solution found
for your picture or TV yourself. Check with your dealer or call a TV technician.
sound problem ?
Have you selected the wrong menu? Press the
Menu
menu.
• Check if the remote control is in the correct mode.
Remote control
• If your TV no longer responds to the remote control, the batteries may be dead.
Standby Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution. Power consumption: <3 W.
If S-VHS is disconnected, picture color will become faint.To restore picture color,
S-VHS color
becomes faint press the P+ button on the remote control to do a channel up followed by
pressing the P– button to do a channel down.
10
equipment or neon lights, etc.?
Sometimes you can improve the picture quality by changing the direction of the
aerial.
frequency. See Store TV channels, Manual store,p. 7.
other aerial to your recorder, the VGA cables to the display, the power cables.)
this means that the display mode is not supported. Switch your VGA-source to a
correct mode.
key again to exit from the
MENU