LANCOM 800 Installationsanleitung Seite 23

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers
7
Downloaded from www.Manualslib.com
server, then the device can be accessed by the name "LANCOM <MAC
address>" (e.g. "LANCOM-00a057xxxxxx").
http://LANCOM-00a05700094A
The MAC address can be found on a label at the bottom of the device.

If there is no DNS server in the LAN, or it is not linked to the DHCP server,
then the device can not be reached by the name. The following options
remain in this case:
Figure out the DHCP-assigned IP address of the LANCOM by suitable
tools and contact the device directly with this IP address.
Use LANconfig.
Connect a PC with a terminal program via the serial configuration
interface to the device.Connect a PC with a terminal program via the
serial configuration interface to the device.
... via serial interface
If no LAN access can be established to the device,
serial configuration interface
LANconfig or a
For outband configuration via terminal program it is not possible to

use setup wizards. The use of LANconfig is again the most convenient
configuration method.
... via dial-up networking/ISDN connection (remote
configuration)
If your device is reachable at a remote location via ISDN, you can confi-
gurate it remotely with LANconfig. Further information about
configuration
manuals search engine
and carry out the configuration via
terminal program.
can be found in the reference manual.
First steps
connect the PC via the
remote