Installing Software; Setting Up And Connecting The Device - LANCOM 800 Installationsanleitung

Downloaded from www.Manualslib.com
LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers

Installing software

If you use a Windows PC for configuration, you should
(LANconfig and LANmonitor of the included CD).
Alternatively, or in case of other operating systems, it is possible to
web browser

Setting up and connecting the device

Put up LANCOM/mount. While doing so, please
advices regarding the ambient conditions, stackability etc. of the technical
data in the User's
Some devices (e.g. with integrated ADSL modem) may become quite

warm in operation. For these models, ensure an ambient air tempera-
ture of 35°C at maximum. Take care of sufficient ventilation. Do not
stack devices and do not expose them to direct insolation!
Install/connect
necessary.
Antennas are only to be attached or changed when the device is

switched off. Mounting or demounting antennas while the device is
switched on may cause the destruction of the WLAN module! When
installing outdoor antennas, the instructions on installation and
grounding in the LANCOM Outdoor Wireless Guide must be observed.
Connect LAN and WAN ports
When connecting the Ethernet interfaces, please ensure that the two

devices being connected (e.g. switch and LANCOM) both have the
same setting for auto mode. If a LANCOM is connected to a switch
that does not support auto mode, or if this function has been
deactivated in the switch, then auto mode must also be deactivated
manuals search engine
for configuration.
Manual.
additional antennas
to the corresponding remote stations.
First steps
Install LANtools
follow the installation
for LANCOM Wireless devices, if
use a
2