Device Description; Overview - Model Number; Unpacking The Device; Installation - Abus HDCC81000 Bedienungsanleitung

4. Device description

4.1 Overview – Model number
Model number
Resolution
IP66
IR, infrared
Operating voltage

4.2 Unpacking the device

Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, start by inspecting the device. If the device
shows signs of damage, return it in the original packaging and inform the delivery service.

5. Installation

Instructions and installation variants for the dome cameras can be found in the quick start guide for
the PTZ cameras. Please consult this guide before you proceed with the installation.

6. Quickstart guide for control units

The high-speed motorised dome can be controlled with all RS485 devices that have the Pelco D or
Pelco P protocol.
For additional information, please refer to the relevant user manual.

6.1 Control with control panel TVAC26000

The TVAC26000 control panel has been specially developed for controlling the HDCC81000 and
HDCC82500 high-speed motorised domes and therefore supports all camera functions.
For all further information on connection and operation, refer to the control panel instruction manual.

6.2 Control with analogue HD video recorder (HDCC9XXXX)

In analog HD DVR PTZ Dome can be controlled using the PTZ control panel. The connection of the
analog HD PTZ Domes can be carried out exclusively via the video cable (coax). The control data is
sent over the cable (up to 200m).
HDCC81000
720p
-
-
24 VAC
If the Steuerput is connected directly to the analog HD DVR and the PTZ dome to be
controlled above, the following setting must be checked.
DVR menu: Menu -> Settings -> Configuration -> General -> Advanced Settings ->
Device number = eg 1.
The default setting for this value is 255. This value must be changed in this case.
HDCC82500
1080p


24 VAC
28