Stramatel FRC AD Technische Daten - Montageanleitung Seite 14

Outdoor
Installation on on a wall or on a support frame - Scoreboard installation
In order to make the installation easier, the anchor points (I), located on the top side of the modules can be used (NB: Anchor points = insert
holes in aluminium frame). If you want to use them to lift or install the modules, replace the black plastic screws by M6x40 eyescrews
(closed rings, not supplied). Caution: the black plastic screws should not be used to lift or fix the modules (they are only dedicated to protect
the scoreboard from water intrusion).
Each module is noted with a sticker Mxx. Please strictly follow the below instructions.
Lift the module M1 near the brackets.
If the pre-installed (electrical) supply is behind the scoreboard: turn off the electrical power, then connect the mains cable with the pre-
installed (electrical) supply (see chapter "Electrical installation" – "Mains cable"). The scoreboard must not be connected to mains until the
installation has been fully completed.
Place the module M1 between the brackets. Leave a space clear of at least 20mm between the module and the wall.
Fix the module M1 with the brackets by using the supplied stainless steel screws & washers Ø6mm (anchor points (I)).
Place the module M2 above the module M1. Leave a space clear of at least 20mm between the module and the wall.
Fix the module M2 with the brackets by using the supplied stainless steel screws & washers Ø6mm (anchor points (I)).
Plug in the connectors (Y) between the modules and slide them into the back of the scoreboard.
Place the module M3 above the module M2. Leave a space clear of at least 20mm between the module and the wall.
Fix the module M3 with the brackets by using the supplied stainless steel screws & washers Ø6mm (anchor points (I)).
Put the black plastic screws back into anchor points (I) located on the top side of the module M3.
Plug in the connectors (Y) between the modules and slide them into the back of the scoreboard.
I
I
I
I
I
I
Y
I
I
I
ZI de Bel Air 44850 LE CELLIER FRANCE
IA452FRCAD-IM_F - Installation FRCAD
M3
M2
M1
stramatel@stramatel.com Tél. +33 (0)2 40 25 46 90
I
I
I
Y
I
I
I
Y
I
I
I
Page 7