Before Use - Claas BA-1383 Bedienungsanleitung

Other display symbols:

4 Before Use

1. Check that the probe is dry and clean and that the device appears undamaged.
2. Install or change the battery as illustrated.
Power on by pressing the l key.
3.
4. Configure device settings to suit your preferences, see chapter 5.
5. Run the quick calibration procedure (see chapter 9.2).
Pull battery plug out.
Insert a fresh battery
(observe polarity).
5 Settings
Power on by pressing the l key.
1.
2. There is a menu symbol
menu by pressing the l key located below it.
Use the arrow keys u or d, until "+SETTINGS" text is chosen (light text on dark
3.
background; "+SETTINGS" in English) and press the e key.
The settings menu contains the following settings:

Display language selection ("Language" in English)

Temperature unit selection (degrees of Celsius or Fahrenheit)
Select
Store to memory
Go back / up / down
Battery should be replaced
Malfunction. Remove the battery, wait a short while and re-
place the battery. Power on. If fault repeats, take a note of the
error code number displayed next to this symbol and contact
your dealer or an authorized Wile service partner
Measurement memory is almost full. See chapters 7 and 8 for
instructions on memory clearing
Lock battery in its
place by pressing in
and down
at the bottom left corner of the display. Enter the main
3
Release battery by pressing in and
tilting up.
Replace the battery plug.