Makita DTM40 Bedienungsanleitung Seite 8

Low battery voltage:
•
The remaining battery capacity is too low and
the tool will not operate. In this situation,
remove and recharge the battery.
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
Fig.3
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Lighted
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
Fig.4
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the tool is switched off.
To start the tool, slide the slide switch toward the "I (ON)"
position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.
Adjusting the orbital stroke rate
Fig.5
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 6. The
higher the number is, the higher the orbital stroke rate is.
Preset the dial to the number suitable for your
workpiece.
NOTE:
The dial cannot be turned directly from 1 to 6 or
•
from 6 to 1. Forcing the dial may damage the tool.
Downloaded from www.Manualslib.com
Indicator lamps
Off Blinking
malfunctioned.
manuals search engine
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Lighting up the front lamp
WARNING:
Never look into the light directly. Direct light causes
•
damage to your eyes.
Fig.6
Slide the slide switch toward the "I (ON)" position to light
up the front lamp. The lamp keeps on lighting while the
switch is the "I (ON)" position. The light automatically
goes out after pressing the rear of the slide switch, and
then sliding the slide switch toward the "O (OFF)"
position.
Remaining
Overload protection
capacity
When the tool is overloaded and the tool temperature
reaches a certain level, the front lamp blinks and the tool
75% to 100%
automatically stops. Remove a cause of overload to
restart.
50% to 75%
Indication lamp
25% to 50%
Fig.7
When the remaining battery capacity gets low, the
0% to 25% •
indication lamp blinks.
Charge the
When the remaining battery capacity gets much
•
battery.
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
The battery
At this time, remove the battery cartridge from the tool
may have
and charge it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
Do not install application tool upside down.
•
Installing application tool upside down may
damage the tool and cause serious personal injury.
Install attachment tool in the correct direction
•
according to your work. Application tool can be
installed at an angle of every 30 degree.
Fig.8
Fig.9
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches
the sanding pad direction.
8