Vestfrost ULTF 40 Bedienungsanleitung Seite 14

14 Vestfrostsolutions�com
Models VTS098/ULTF 40
LEDS
Each LED function is described in the following table�
LED MODE
ON
Flashing
ON
ON
ON
Flashing
Flashing
°C/°F ON
°C/°F Flashing
Buttons
SET To display target set point in programming mode it selects a parameter og
confirm an operation�
(UP) To enter fast access menu In programming mode it browses the
parameter codes or increases the displayed value�
(DOWN) In programming mode it browses the parameter codes or de-
creases the displayed value�
DATA
Export data from button�
Not relevant�
REC Log activation and deactivation from button (Password protected)�
Function
Compressor enabled
Anti-short cycle delay enabled
An alarm is occurring
Recording activated
Battery status OK
Battery is beeing charged
Charging problem or battery failure
Measurement unit
Programming phase
EN