System Requirements; Specification - i-tec ADUANCE-Serie Gebrauchsanweisung

i-tec USB-C 3.1 Slim HUB 4 Port Passive
INTRODUCTION
i-tec USB-C 3.1 HUB is an ideal companion for everybody who does not have enough USB ports in
his/her notebook, ultrabook or PC and who has to constantly connect and disconnect his/her favorite
USB equipment such as flash disks, mobile phones, tablets, digital cameras, MP3 players, printers,
etc.
This HUB offers 4 USB 3.0 ports with the Plug & Play function and standard USB charging – the HUB
will automatically detect connected equipment for USB charging. The USB 3.0 interface is important
mainly for data transfers from USB 3.0 memory cards and flash disks which will use its high transfer
speed most.
This HUB does not require installation of drivers. You will just connect it by the USB-C cable to your
computer and immediately you can start using it. This HUB has a built in overcurrent protection of
your computer in case of short connection on the peripheries. The interface is compatible with USB
2.0.
Thanks to its compact dimensions and low weight it is an ideal companion to your notebook when
traveling.
INSTALLATION IN WINDOWS 7 / 8 / 8.1 / 10 AND HIGHER, MAC OS, LINUX AND OTHERS
The HUB is installed automatically, no need install drivers. plug the HUB via USB-C 3.1, gen. 1 cable
into available USB-C port of your notebook / PC and follow the on-screen instructions. The HUB will
be installed and displayed in Device manager as "Generic USB Hub" and "Generic USB SuperSpeed
Hub".
DESCRIPTION
1. 4x output USB 3.0 ports for connecting USB equipment
2. LED diode – the diode is ON when the HUB is connected to a USB-C port of a notebook / PC
3. USB-C 3.1, gen. 1 cable for connecting to a notebook / PC
CHARGING
The HUB supports charging of the connected USB mobile equipment such as smartphones
(including iPhone and Samsung phones), e-book readers, multi-media players, GPS navigators, and
tablets (e.g., Asus, Toshiba, GoClever, Prestigio, Emgeton, Sencor). Using the original cable connect
the equipment to be charged to the USB port of the HUB.

SYSTEM REQUIREMENTS

Hardware requirements
Notebook / PC with one available USB-C port
Operating system
Windows 7 32/64bit, Windows 8 32/64bit, Windows 8.1 32/64bit, Windows 10 32/64bit, Mac OS,
Linux, Android 6 or higher, Chrome R51 and higher

SPECIFICATION

4x USB 3.0 port for connecting USB equipment
Ÿ
1x USB-C 3.1, gen. 1 cable for connecting the HUB to a notebook / PC
Ÿ
EN
05
Downloaded from www.Manualslib.com manuals search engine