System Requirements - i-tec U3CHARGEHUB13 Gebrauchsanweisung

EN
DESCRIPTION
1. 13x output USB 3.0 ports for connecting USB equipment
2. LED diode – Next to each USB 3.0 port is a LED which is illuminated by
pressing the switch next to the given port and turns off after pressing the
switch again when the HUB is powered.
3. USB port on/off switch - turns the port on/off.
4. Input for power adapter connection
5. USB 3.0 type A/B port
CHARGING
For proper function the HUB needs the power adapter which is included in
the package. Observe the basic principles of safety when handling this power
adapter (e.g. do not leave it in the reach of children, if the adapter is in the 230V
mains, then do not put the plug in the water, etc.).
CHARGING
The HUB supports charging of the connected USB mobile equipment such as
smartphones (including iPhone and Samsung phones), e-book readers, mul-
ti-media players, GPS navigators, and tablets (e.g., Asus, Toshiba, GoClever,
Prestigio, Emgeton, Sencor). Using the original cable connect the equipment to
be charged to the USB port of the HUB. At the same time the power adaptor needs
to be connected to the HUB as well.

SYSTEM REQUIREMENTS

Windows 7 / 8 / 8.1 / 10, Mac OS X 10.6 or higher, Linux, Chrome OS
SPECIFICATION
• 13x USB 3.0 port for connecting USB equipment
• 1x USB 3.0 cable for connecting the HUB to a notebook / PC
• Transfer rate up to 5 Gbps
• USB charging detection mechanism for mobile devices
• Plug & Play function
• Overload and overcurrent protection
• LED diode
• Storage temperature -10~85 °C
• Working temperature 0-50 °C
• Power adapter: input AC 100-240 V, 50-60 Hz, 1.5 A; output DC 12 V, 5 A
• OS Windows 7 / 8 / 8.1 / 10, Mac OS X 10.6 or higher, Linux, Chrome OS
• Product dimensions 187 x 53 x 23 mm
• Product weight 200 g
6
Quick Start / USB 3.0 Charging HUB 13 Port