Dometic WAECO MagicSpeed MS900 Montageanleitung Seite 30

Connecting the electrical power to MagicSpeed
All types of vehicle except Opel Movano/Vivaro up to 2008:
Connect the red wire of the CAN bus wiring harness (fig. 9, page 6):
– Disconnect the yellow/red wire (1) from socket 1 of the diagnostic plug
– Connect the yellow/red wire (1) to the red wire (2) of the CAN bus wir-
– Protect the connection using an insulating sleeve (3)
– Connect the red wire (4) of the CAN bus wiring harness to socket 1 of
Put the plug protector (fig. 0 1, page 7) onto the diagnostic plug.
Opel Movano/Vivaro from 2008 only:
Connect the red wire of the CAN bus wiring harness (fig. a, page 7):
– Disconnect the yellow/red wire (1) from socket 1 of the ESP plug
– Connect the yellow/red wire (1) to the red wire (2) of the CAN bus wir-
– Protect the connection using an insulating sleeve (3)
– Connect the red wire (4) of the CAN bus wiring harness to socket 1 of
Connecting the main wiring harness
Disconnect the vehicle's plug (fig. b 1, page 8) from the accelerator
pedal (fig. b 2, page 8).
Connect the main wiring harness to the accelerator pedal (fig. c,
page 8):
– Connect the plug of the main wiring harness (1) to the accelerator
– Connect the vehicle's plug (2) to the socket (3) on the main wiring
Connecting the electronic module
Insert the 16-pin plug on the main wiring harness into the socket on the
electronic module (fig. d 5, page 9).
Insert the 4-pin plug on the CAN bus into the socket on the electronic
module (fig. d 6, page 9).
Insert the 8-pin plug of the control element into the socket on the electron-
ic module (fig. d 7, page 9).
Connect the battery.
30
Downloaded from www.Manualslib.com
ing harness
the diagnostic plug
ing harness
the ESP plug
pedal
harness
manuals search engine
MagicSpeed