Dometic WAECO MagicSpeed MS900 Montageanleitung Seite 29

MagicSpeed
7.2
You will find a summary of the wiring in fig. d, page 9.
No.
1
2
3
4
Connecting the wiring harness for the CAN bus
Disconnect the battery.
Pull the plug protector (fig. 6 2, page 5) off the diagnostic plug (fig. 6 2,
page 5).
The wires can now be disconnected with a screwdriver (fig. 6 A,
page 5).
Connect the blue wire of the CAN bus wiring harness (fig. 7, page 5):
– Disconnect the purple/red wire (1) from socket 14 of the diagnostic
– Connect the purple/red wire (1) to the blue wire (2) of the CAN bus
– Protect the connection using an insulating sleeve (3)
– Connect the blue wire (4) of the CAN bus wiring harness to socket 14
Connect the pink wire of the CAN bus wiring harness (fig. 8, page 6):
– Disconnect the white/red wire (1) from socket 6 of the diagnostic plug
– Connect the white/red wire (1) to the pink wire (2) of the CAN bus wir-
– Protect the connection using an insulating sleeve (3)
– Connect the pink wire (4) of the CAN wiring harness to socket 6 of the
Downloaded from www.Manualslib.com
Laying and connecting the cable
Component
Electronic module
Diagnostic plug
Main wiring harness
Vehicle CAN bus wire
plug
wiring harness
of the diagnostic plug
ing harness
diagnostic plug
manuals search engine
Connecting the electrical power to MagicSpeed
No. Component
5 Main wiring harness con-
nection
6 CAN bus connection
7 Control element connection
8 ESP switch
29