Door Space Requirements; Leveling The Unit - INVENTOR INVMS67A Bedienungsanleitung

4) Slide the appliance door down about 15cm and off the
top hinge pin and li away from the appliance.
5) Remove the two screws from top bracket and replace
on the other side. You will need to first remove the plas c caps
from the other side.
6) Slide the appliance door back on to the Top hinge,
making sure
Screw the bo om hinge into place on the new side.
Replace the other foot on the other side. Replace the
door hinge.
7) Check that the door is aligned horizontally and
ver cally and that the seals are closed on all sides
before finally ghtening the bo om hinge.
Re-adjust the leveling feet.

Door Space Requirements

2.3
The unit's door must be able to open fully as shown.

Leveling the Unit

2.4
To do this, adjust the two leveling feet at the front of the unit.
If the unit is not level, the door and magne c seal alignments
will not be covered properly.
3
8 8 0