Information On Display Panel; Temperature Problem; Noise - Siemens KI81F Serie Gebrauchsanleitung

Information on display panel

Fault
or appears in the tem-
perature display.
A warning signal sounds and
lights up.

Temperature problem

Fault
The temperature differs
greatly from the setting.
Cool-fresh compartment is
too warm or cold.

Noise

Fault
Appliance has a humming
sound.
Cause
The electronics have detec-
ted a fault.
Different causes are pos-
sible.
The appliance door is open.
Cause
Different causes are pos-
sible.
Standard setting is too high
or too low, e.g. frost in cool-
fresh compartment.
Cause
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
Troubleshooting en
troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 50
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
troubleshooting
Switch off the appliance.
1.
→ Page 41
Switch the appliance back on after
2.
five minutes. → Page 41
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
Note: The standard setting of the cool-
fresh compartment is preset at 0. Set-
ting 0 corresponds to a temperature of
around 0 °C. You can set the temperat-
ure in the cool-fresh compartment to
3 settings warmer or colder.
Press until the temperature
1.
display flashes.
To change the setting, press / .
2.
– Setting –3 corresponds to the
coldest setting.
– Setting +3 corresponds to the
warmest setting.
a The selected setting is saved after
one minute.
troubleshooting
No action required.
47