Check Alarm - RIBA R-55 Handbuch

Check Alarm:

There are two types of check alarm. (Please refer to Check alarm type of Parameters setting. P13)
★
Inside type:
The alarm sounds beeps and display value flickers when total weight falls inside the set range.
When the weight is ourtside the set range, display will show "H" or "L" before the total weight.
★
Outside type:
The alarm sounds beeps and display value flickers only when total weight falls outside the set
range. When it is between the both limits value, beeper will be off and the display won't flicker.
Clear high / low preset value
Follow the above preset procedures and key in "0" directly for high and low limit values.
* Press "Units/
or Check-W./
Section 5.0 Preset weight check range.)
* Press "Zero/Enter" key for determination and exit from the parameter setting mode.
Using the backlight, yes or no:
* Press " Mode/ and Zero/Enter" key at the same time in weighing or counting mode to enter into
parameters setting.
or Check-W./
* Press
"Units/
to the below form.
* Press "mode" key to turn the backlight (light in the display) of or on.
Model Backlight type
R55
Press Zero/Enter key to confirm and return to next setting.
Power supply & battery operation
Power supply
● Rechargeable battery 6v/5Ah
● DC 9V/700 mA
Battery Operation
The scale can be operated from the battery if desired. The battery life is approximately 50 hours.
When the battery needs charging a symbol "
still operate for about 10 hours after which it will automatically switch off to protect the battery.
To charge the battery, simply attach the power supply module to the scale and plug in. The scale does not
need to be turned on.The battery should be charged for 12 hours for full capacity.
© RIBA WEEGTECHNIEK BV
" key to set the check alarm type to be "IN" or "OUT". (Please refer to
" to set the backlight type to be "bl. 1","bl. 2"or "bl. 3". Please refer
BL.1
BL.2
BL.3
Description
Automatical backlight
Backlight is always on
Backlight is off
" on the weight display will turn on. The scale will
22