Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Taring function :
Please install the balance in the right place the right way.
The weight of any container can be tared by pressing a button so that with subsequent weighing the net
weight of the object being weighed is always displayed:
* Place the empty tare container on the balance. The total weight of the tare container is displayed.
* Press "Tare/
" key to start the taring process.
* Place the full tare container on the balance.
You can now read the weight from the display.
* Press "Tare/
" key again to stop the taring process.
Put the weight on the balance very carefully. Don't shake the balance. This can harm the loadcell.
Remove the weight from the balance if you are done weighing.
Note: Tare range is the full capacity of the scale.
Counting Mode:
Counting:
* Sampling: Press Mode/
(the display shows C-1000pcs).
* After entering into counting mode,press the "Units/
(10,20,50,100,200,500,1000pcs).
* Put the sample number on the scale and press "Zero/Enter" key. When the symbol" C 10 "
disappears the sampling procedure is finished and you can start to use the counting function.
* If the unit weight is too small (less than 0.2 or 0.04d of a scale division),
the display will show"E4".
* Press "Mode/
Preset weight check range
Check-weighing:
Users can set a Hi – Lo range for weight check when the weight of objects on the pan is within
the preset weight check range, the alarm will sound beeps repeatedly and the displaying weight
will flicker.
* Press "Check-W./
* When dislay shows"H00000", key in the desired high limit value. (Use " Units/
"Check-W./
" key to move the shifting digits to left or right.Then press" Zero/Enter " key to
Tare/
confirm)
* When the display shows "L00000", key in the desired low limit value the same way as high
value.
* After low limit value be set, press "Zero/Enter" key for determination and exit from the limits
setting mode.
Note: The display will show "Err 5" when low limit value is set to be higher than the high limit value.
© RIBA WEEGTECHNIEK BV
key in weighing mode to enter into counting mode
" key again to back to weighing mode.
" key to enter into the presetting check-weight mode.
"key to increment or decrease the shifting digits and use "Mode/
" key to select the sample size
" or
or
21
Werbung
Inhaltsverzeichnis
