Villeroy & Boch Magic Basin Bedienungs- Und Montageanleitung Seite 16

Programme No. 7
Activation: Hands in middle of basin = warm
Hand on blue dot = cold
Hand on red dot = very warm
Deactivation: Remove hands from jet of water
Comments: Rinse with cold water for 3 sec. after use
3 temperature levels can be selected
No audio signal to confirm temperature selection
Maximum ON time 2 min.
Programme No. 8
Activation: Touch chrome ring of water inlet = warm
Hand on blue dot = cold
Hand on red dot = very warm
Deactivation: Hand on blue dot for 2 seconds
Comments: Rinse with cold water for 3 sec. after use
3 temperature levels can be selected
Temperature selection confirmed by audio signal
Maximum ON time 5 min.
Programme No. 9
Activation: Touch chrome ring of water inlet = warm
Hand on blue dot = cold
Hand on red dot = very warm
Deactivation: Hand on blue dot for 2 seconds
Comments: Rinse with cold water for 3 sec. after use
3 temperature levels can be selected
No audio signal to confirm temperature selection
Maximum ON time 5 min.
G
No audio tone sounds when
the battery is inserted:
– Insert batteries correctly
(polarity)
– Turn batteries in the holder
until contact is established
– Insert new batteries
Flow of water does not stop
after removing hands:
– Recalibrate Magic Basin (pro-
cedure as for battery change)
– Clean solenoid valves
Continuous flow of water:
– Clean solenoid valves
Minimal flow of water:
– Clean filter
– Open corner valves completely
– Check water supply
No flow of water when
activated:
– Check water supply and
recalibrate (see battery
changing procedure)
– Replace batteries
– Check sensor connection
Troubleshooting
No flow of water,
audio signal sounds:
– Batteries dead > > Replace
batteries
Audio signal sounds
after use:
– Battery power declining > >
Replace batteries
Water flow too strong:
– Fit flow limiter
(see installation, page 21,
fig. 10)
Hot water temperature
too high:
– Turn hexagon socket head
screw on valve block in
clockwise direction
Magic Basin
30
|
31