Heatsail DISC Betriebsanleitung Seite 54

Reprogramming the remote:
Open the control box and locate the dimmer module.
(1) Switch on the main power
(2) Be aware of any exposed wiring
(3) Find the "Learning Key" on the dimmer module
A1-A2: 8-230V
Min.Set Learning
Key
max.
400W AC 100-240V
L L N
Register transmitter with the receiver
(1) Press the "Learning Key" for one second. The search mode will be active
for a short period.
(2) Send a signal to the receiver with the remote by clicking one of the buttons
on the remote control. If this is first use of the DISC, please be sure that the
protective film on the battery of the remote is removed.
(3) The receiver will store the applicable transmission code in the receivers
memory. If the device successfully paired with the remote, the light of the
DISC will light up briefly (1-2 seconds).
Repeat this procedure to register several remotes, if required. The receiver
can store up to eight transmission codes in its memory. The memory will be
retained if you install the receiver somewhere else or if the power goes off.
Disconnect remote
Put left switch (marked DIM - 0 - ON) on DIM, press within 30 seconds
6seconds on the off button of the remote. The light will go on and off. Remote
is disconnected.
N
N
L
H1 H2
Front side