Operation - Heatsail DISC Betriebsanleitung

7.

Operation

Activate your DISC
After the DISC is wired to a suitable power outlet, the DISC may be powered
on. The right switch (marked LOW - 0 - HIGH) switches the heater on. On
"LOW" only three side elements heat, on "HIGH" all five side elements
and the round bottom element are providing heat. "0" switches the
heater off. When you switch on the DISC, it takes up to 30 minutes before
the DISC reaches its full temperature. When switched off, it may take
up to 40 minutes before the DISC has completely cooled down.
The left switch (marked DIM - 0 - ON) manually controls the light.
"DIM" ENABLES THE REMOTE
Enable the light with remote
"O" LIGHT OFF
Switch off the light without the remote
"ON" LIGHT ON
Switch on the light without the remote
Brightness down*
Off
Power off
Brightness down
25% Brightness
25% Brightness
75% Brightness
75% Brightness
No function
Not used
On
Power on
Brightness up*
Brightness up
50% Brightness
50% Brightness
100% Brightness
100% Brightness
H1 H2 No function
Not used
NOTE: Before first use, please
open the battery cover of the
remote and remove the
protective film on the battery if
still present.
Top view
Top view
* Hold down these buttons.
LOW
DIM
0
0
HIGH
ON
Located on the back
of the panel of the
base of the DISC.