Maintenance - Heatsail DISC Betriebsanleitung

To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 100 cm (40 inches) from the DISC. Never
cover your DISC without disconnecting power to the unit!
The DISC must never be touched with bare, wet or damp body parts.
The DISC is constructed of six high radiance ceramic heating elements,
mounted on a reflective plate. The full operating temperature will be
reached within 30 minutes.
Please note: there is no noticeable glow in the infrared area.
Never use the DISC to light anything. The ceramic elements are fragile
and must be handled with care. The same also applies to the glass casing.
Always ensure that the DISC is anchored on a flat surface before use.
Always keep the DISC free of snow.
The DISC is not allowed for use in greenhouses or building sites.
Heatsail will not be held responsible for damage resulting from
non-compliance with the instructions regarding use and maintenance.
3.

Maintenance

3.1 Cleaning
Your DISC must be cleaned on a monthly basis.
The electrical supply must be disconnected via the installation's breaker
switch and by disconnecting the wiring before cleaning activities can
commence. Cleaning may only be done with a dry and soft cloth. Do not
use any abrasive cloths. Do not use detergents. Using a high pressure
and/or steam cleaner is prohibited. Cleaning is only permitted once the
DISC has completely cooled down.
Non-compliance with these rules may compromise the safety of the
device. Heatsail will not be held responsible for damage resulting from
non-compliance with the cleaning instructions.