Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to use
mode, the baby unit emits a signal to
the adult unit at regular intervals to
A, Baby unit (transmitter)
make sure they are in contact with
1. Switch the power on by pushing the
each other. This is indicated by the
Power switch (1) from O to I. When
red light.
the power is on, the Power supply
5. Place the baby unit near your child,
indicator (3) lights up steady green.
with the microphone facing the child.
If the indicator starts blinking red,
Make sure the unit is close enough
the unit needs to be charged.
to pick up sounds from your child,
2. Select one of the ten channels on
but not so close that your child can
the Channel selector (8). You need
reach it. 1 metre (3.2 feet) is a good
to use a coin or similar object to
distance.
turn the channel selector to the
desired position. This is a precaution
B, Adult unit (receiver)
to prevent the unit from switching
NOTE! Make sure the adult unit is at least
channels accidentally.
a couple of metres away from the baby
3. You can adjust the sensitivity of the
unit before you switch it on. If the units
microphone from 1 to 8 using the
are too close to each other, feedback
Microphone sensitivity control (2).
between the units can create a loud
The microphone is most sensitive to
screeching noise.
sound when it is set to 8, and least
sensitive when it is set to 1. If there
1. Switch the power on by pushing the
is a lot of background noise, it's a
Power switch (9) from O to I. When
good idea to lower the microphone
the power is on, the Power supply
sensitivity. If the surroundings are
indicator (11) lights up steady green.
quiet, the microphone sensitivity can
If the indicator starts blinking red,
be set higher.
the unit needs to be charged.
4. The Transmitting indicator (4) lights
2. Select the same channel for this
up red when it picks up sound. It
unit as for the baby unit, using the
stays lit for 5 seconds after the sound
Channel selector (16). In case you
has stopped, before it goes back to
notice any interference or static
stand-by mode. In stand-by mode,
noises, select another channel and
the light is green. While in stand-by
implement on both units.
6
Werbung
