AGP TC402 Bedienungsanleitung Seite 8

GB
USING THE WATER SUPPLY KIT
(optional)
Mount the water supply collar onto the gearbox neck and secure with the screw.
To connect to the water supply, attach the quick-release water coupling to a water hose and then snap the
coupling into position. Use the valve to regulate the water flow.
USING THE WATER TANK
(optional)
Make sure the flow regulator knob is closed and fill the tank with clean water. Mount the tank's collar onto the
gearbox neck and tighten the screw to fix in place.
With the flow regulator knob in the closed position, pump the hand pump to create pressure in the tank.
When ready to drill, open the flow regulator knob and adjust the water flow to the desired amount. Close the
flow regulator knob when the hole is finished.
WARNING: Remove the tank from the motor when refilling. Never allow water to enter the motor.
CAUTION: Always empty the water tank whenever storing incase or transporting.
CAUTION: Never allow the water to freeze in the water tank.
SPECIAL INSTRUCTIONS FOR DRY DRILLING
Dry drilling is a different process from wet drilling. Wth dry drilling, it is more of a cutting process and you must
use a much lighter touch.
Allow the tool to work at its own pace.
Dry drilling is normally done in softer materials. Note that in very hard materials it may not be possible to drill
dry. Always use a vacuum cleaner to control the dust from dry drilling.
SELECTING SPEEDS
There are 2 speed ranges to suit the bit size and work piece hardness.
Chooset speed 1 for about 20mm to 40mm diameter bits and hard
materials. Choose speed 2 for about 5mm to 20mm bits.
Gear Selector
CAUTION: Never attempt to change gears on a running machine!
Only adjust when the machine is at rest.
Pop the Gear Selector Tab out of the detent then slide the selector back for low or forward for high to change
the gear. It may be necessary to turn the spindle slightly in order for the gear to be engaged. Once engaged,
pop the tab into its detent.
8