Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Symbols used in this manual
V.............volts
A.............amperes
Hz............hertz
W............watt
~.............alternating current
n
...........no load speed
0
min
........revolutions or reciprocation
-1
per minute
......warning of general danger
. .....class II tool
DRILL SAFETY WARNINGS
1.
Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
2.
Take care not to damage gas, water, power and other conduits in the area of the drilling operation.
Drain or shut off these conduits as required.
3.
Block off the working area and place warning signs on both sides of the wall when drilling through
from one side to the other.
4.
When drilling hollow components, check the flow route of the cooling water in order to prevent
damage.
5.
Always hold the machine tightly. Diamond core drilling bits can become stuck at any time during core
drilling, there is a danger of the machine jumping out of control.
6.
WARNING: Pull the plug out of the socket before making device settings or changing accessories.
Many accidents are caused by accidental starting of power tools.
SPECIAL SAFETY WARNINGS FOR WET DRILLING
1.
Never use the machine without the PRCD fault-current safety switch supplied.
2.
Always check the PRCD fault-current safety switch for correct functioning before starting a drilling
operation.
3.
Ensure that no water is allowed to get into the motor unit during operation.
4.
If you detect a leak in any part of the water supply system, shut the machine down immediately
and repair the fault. Water pressure should not exceed 70 psi (4 bar).
5.
Check all connections of the water feed system to ensure there are no leaks. Inspect hoses and
other critical parts which could deteriorate.
6.
Use a water collector with a wet vacuum to collect cooling water if nearby objects could be
GB
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
5
Werbung
Inhaltsverzeichnis
