NEFF K345 Serie Gebrauchsanleitung Seite 41

Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the food and store in a cool
location. Place ice pack (if available)
on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
pan.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the food back into the appliance.
Notes
Regularly clean the condensation
■
channel and drainage hole, Fig. */B,
with a cotton bud to ensure that
the condensation can drain. The water
conduction channel, Fig. */A, can be
taken out for cleaning.
After cleaning, the stopper must be re-
■
inserted into the drainage hole
of the refrigerator compartment for
functional reasons.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Taking out the glass shelf "EasyLift"
Fig. $
Move glass shelf all the way upwards
and take out.
Taking out the fixed glass shelf
Fig. %
Press buttons on the underside and
detach from the fixing.
Taking out the door shelf "EasyLift"
Fig. &
Move door shelf all the way upwards and
take out.
Taking out the butter and cheese
compartment
Fig. (
To clean the compartment, lift it at
the bottom and take out.
Taking out the frozen food container
Fig. +
Pull out the frozen food container all
the way, lift at the front and remove.
Note
Before inserting the frozen food
container with telescopic rails, remove
the latter.
Removing the container
Fig. -
Tilt container forwards and take out.
To insert the container, place the front
of the container on the telescopic rails
and push into the appliance.
The container is engaged by pushing it
into the appliance.
Taking out the humidity filter
Fig. !/21
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. ,, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
en
41