Network Switch Module - Dell PowerEdge 1655MC Anleitung Für Die Systemkonfiguration

0w440eb1.fm Page 8 Monday, October 28, 2002 2:23 PM
1-8 System Configuration Guide
Downloaded from www.Manualslib.com
F i g u r e 1 - 4 . N e t w o r k S w i t c h M o d u l e
link indicators (4)
RJ11 serial port for
network switch
module setup
You can configure the network switch module either through the serial port on the system
management module or by using the RJ11 serial null modem cable connected to the RJ11
serial port on the network switch module. A DB9–to–RJ11 cable is provided with the
network switch. Dell recommends using the serial port on the system management module
to configure the network switch module.
NOTE: Do not connect the RJ11 configuration port to a data or telephone network. Do
not connect the RJ11 serial cable to any of the 10/100/1000 BASE-T uplink ports.
To configure the network switch module using the serial port on the system management
module, perform the following steps:
Perform steps 1 through 14 in "Configuring the Client System."
1
After you have logged into the remote access portion of the system management
2
module, select one of the network switch modules.
• Type connect switch-1 to connect to the top network switch module.
• Type connect switch-2 to connect to the bottom network switch module.
To log on to the network switch module console, type:
3
Username-admin
Password-admin
You are logged into the switch console. By default, the switch is DHCP client-enabled.
To obtain the IP address of the network switch module, type #sh ip interface.
4
manuals search engine
activity indicators (4)
10/100/1000
BASE-T uplink
ports (4)
reset button
system fault
indicator