Sharp Aquos LC-32WD1E Bedienungsanleitung Seite 2

The mains lead of this product is tted with a non-rewireable (moulded) plug incorporating a 5A fuse. Should the fuse
need to be replaced, a BSI or ASTA approved BS 1362 fuse marked
also indicated on the pin face of the plug, must be used.
Always re t the fuse cover after replacing the fuse. Never use the plug without the fuse cover tted.
In the unlikely ev
plug and t an appropriate type.
DANGER:
The fuse from the cut-o plug should be removed and the cut-o plug destroyed immediately and disposed of in a safe
manner.
Under no circumstances should the cut-o plug be inserted elsewhere into a 13A socket outlet, as a serious electric
shock may occur.
To t an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT:
The wires in the mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
• The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black.
• The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red.
Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-pin plug.
Before replacing the plug cover make sure that:
• If the new tted plug contains a fuse, its value is the same as that removed from the cut-o plug.
• The cord grip is clamped over the sheath of the mains lead, and not simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SPECIAL NOTE FOR USERS IN THE U.K.
or and of the same rating as above, which is
the mains