Adjusting The Centering Of The Picture (Center); Enlarging Or Reducing The Picture (Zoom); Adjusting The Shape Of The Picture (Geom); Adjusting The Convergence (Conv) - Sony Trinitron GDM-F500R Bedienungsanleitung

Adjusting the centering of the
picture (CENTER)
This setting is stored in memory for the current input signal.
1
Press the joystick.
The main MENU appears on the screen.
2
Move the joystick to highlight
press the joystick again.
The SIZE/CENTER menu appears on the screen.
3
First move the joystick up or down to select
horizontal adjustment, or
Then move the joystick left or right to adjust the
centering.
Enlarging or reducing the picture
(ZOOM)
This setting is stored in memory for the current input signal.
1
Press the joystick.
The main MENU appears on the screen.
2
Move the joystick to highlight
CENTER and press the joystick again.
The SIZE/CENTER menu appears on the screen.
3
Move the joystick up or down to select
and move the joystick left or right to enlarge or
reduce the picture.
Note
Adjustment stops when either the horizontal or vertical size reaches its
maximum or minimum value.
Adjusting the shape of the picture
(GEOM)
The GEOM settings allow you to adjust the rotation and shape of
the picture.
The (rotation) setting is stored in memory for all input signals.
All other settings are stored in memory for the current input
signal.
1
Press the joystick.
The main MENU appears on the screen.
2
Move the joystick to highlight
the joystick again.
The GEOMETRY menu appears on the screen.
12
CENTER and
for
for vertical adjustment.
SIZE or
(zoom),
GEOM and press
3
First move the joystick up or down to select the
desired adjustment item. Then move the joystick left
or right to make the adjustment.
Select To
rotate the picture
expand or contract the picture sides
shift the picture sides to the left or right
adjust the picture width at the top of the screen
shift the picture to the left or right at the top of the
screen

Adjusting the convergence (CONV)

The CONV settings allow you to adjust the quality of the picture
by controlling the convergence. The convergence refers to the
alignment of the red, green, and blue color signals.
If you see red or blue shadows around letters or lines, adjust the
convergence.
These settings are stored in memory for all input signals.
1
Press the joystick.
The main MENU appears on the screen.
2
Move the joystick to highlight
the joystick again.
The CONVERGENCE menu appears on the screen.
3
First move the joystick up or down to select the
desired adjustment item. Then move the joystick left
or right to make the adjustment.
Select To
horizontally shift red or blue shadows
vertically shift red or blue shadows
vertically shift red or blue shadows at
TOP
the top of the screen
V CONVER TOP
vertically shift red or blue shadows at
BOT
the bottom of the screen
V CONVER
BOTTOM
CONV and press