Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN Power trowel BAS 1500V / BAS 1500E
Customer service and spare parts
3
A
B
2.3 Ending the operation
1.
BAS 1500E:
a.
Press the red OFF button [13].
The electric jogging motor [14] is switched
off.
b.
Pull the connecting cable (extension cable)
from the power socket and roll it up.
BAS 1500V:
a.
Set the lowest speed at the throttle
lever [2].
b.
Press the Stop switch [4] on the
combustion jogging motor [7].
The combustion jogging motor is switched
off.
The operation is ended.
2.
Clean the machine.
2.3.1 Cleaning the machine
The combustion jogging motor [7] may not be
tipped and must always be transport and stored
in work position.
Do not use compressed air, high‐pressure
cleaners or solvents to clean the machine!
—
Clean the machine dry after use with a cloth or
suitable agents.
—
BAS 1500V:
Clean the petrol filter and air filter
(! HONDA GX25 operating manual).
2.3.2 Storing the machine
The following tasks ought to be
carried out by 2 persons.
1.
If the guide bar [1] should remain mounted:
a.
Hold the machine at the guide bar.
b.
Loosen the clamping screw [11] (do not
fully unscrew).
c.
Swivel the guide bar into vertical position
and tighten the clamping screw.
If the guide bar [1] should be removed:
a.
Hold the machine at the guide bar.
b.
Open the securing spring [10], pull out the
cross bolt [9] and remove the guide bar.
c.
Insert the cross bolt [9] into the guide bar
and snap the securing spring [10] over the
guide bar (! illustration).
d.
Push the guide bar between the jogging
motor and smoothing blade [17].
2.
Fasten all loose parts to the machine.
3.
Store the machine in a dry location.
3
Customer service and spare parts
Only manufacturer's original replacement parts
may be used.
In case of customer service queries, replacement
parts or repairs, please contact the manufacturer. To
ensure your queries are dealt with as quickly as pos
sible, always quote your machine data (type, fea
tures).
13
Werbung
Kapitel
Inhaltsverzeichnis
