Nabo 55 ST6600 Bedienungsanleitung Seite 43

Connections
Connector Type
VGA
Connection
(back)
PC/YPbPr
Audio
Connection
(back)
HDMI
Connection
(side&back)
SPDIF
(Optical Out)
Connection
(back)
Back AV
(Audio/Video)
Connection
(back)
Headphone
Connection
(side)
YPbPr Video
Connection
(back)
USB
Connection
(side)
Ethernet
Connection
(back)
If you want to connect a device to the Display, make sure that both the Display and the device are turned off before
making any connection. After the connection is done, you can turn on the units and use them.
Cables
YPbPr/PC Audio Cable
Audio Video Cable
PC to YPbPr Connection Cable
LAN / Ethernet Cable
English - 10 -
See the illustrations on the left
Device
side. You can use YPbPr to VGA
cable to enable YPbPr signal via
VGA input. You cannot use VGA
and YPbPr at the same time. To
enable PC/YPbPr audio, you will
need to use the back audio inputs
with a YPbPr/PC audio cable for
audio connection. When using the
wall mounting kit (available from
a third party in the market, if not
supplied), we recommend that you
plug all your cables into the back
of the Display before mounting on
the wall. The/Each USB input of
your Display supports devices up
to 500mA. Connecting devices
that have current value above
500mA may damage your Display.
When connecting equipment using
a HDMI cable to your Display,
to guarantee sufficient immunity
against parasitic frequency radiation
and trouble-free transmission of
high definition signals, such as 4K
content, you have to use a high
speed shielded (high grade) HDMI
cable with ferrites.