Device Functions - Navitel MSR700 Bedienungsanleitung

Device functions

Video
Photo
Lock file
G-sensor
Parking monitor
Loop recording
Record audio
Battery charging
Screensaver
Downloaded from www.Manualslib.com
Connect the device to an external power supply and it will turn on and start recording automatically
(indicated by the flashing blue light). Press the OK button to stop recording (the blue light will become
steady). Press OK again to record another video. Each video will be saved automatically.
In Capture mode, press the OK button to take a photo. It will be saved automatically.
In Record mode, press Down to lock the current file; a key symbol will appear on the center top of the
screen. In Photo/Video mode, select a file, then press and hold the Menu button to access the context
menu and select Lock Current. Locked files cannot be deleted or overwritten. Select Unlock Current to
remove protection.
If the vehicle is hit by something, the DVR will automatically lock the current recording.
In shutdown state, if vibration is detected, the device will turn on automatically and start recording. The
file will be locked. If nothing happens for over a minute, the device will shut down.
This setting allows saving the recording in separate files every few minutes. For example, if set to 5
minutes, 1 hour of recording will be saved as 12 five minute fragments. If the memory card is full, all
unlocked files will be overwritten in the order they were created.
Record video with or without sound.
Red indicator will light up when the device is plugged into an external power supply; as the battery is
charging, the red will gradually dim; red light going out means the battery is full.
The device can automatically shut off the screen to reduce power consumption; time interval can be set
in the Screen Saver menu.
manuals search engine
NAVITEL MSR700 | 13
EN