Stanley FatMax V20 Bersetzt Von Den Originalanweisungen Seite 10

ENGLISH
LED work light (Fig H)
When drill is activated by pulling the trigger switch (1), the
integrated LED work light (8) will automatically illuminate the
work area.
Note: The work light is for lighting the immediate work surface
and is not intended to be used as a flashlight.
Troubleshooting
Problem Possible cause
Unit will not start. Battery pack not
installed properly.
Battery pack
not charged.
Unit starts The switch has
immediately upon been left in the
inserting battery "on" position.
Battery pack will Battery pack not
not charge. inserted into charger.
Charger not
plugged in.
Surrounding air
temperature too hot or
too cold.
Unit shuts off Battery pack has
abruptly. reached its maximum
thermal limit.
Out of charge. (To
maximize the life of
the battery pack it is
designed to shutoff
abruptly when the
charge is depleted
Maintenance
Your STANLEY FATMAX tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
@
regular cleaning.
Warning! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug the
charger before cleaning it.
● Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
● Regularly clean the motor housing using a damp cloth.
● Do not use any abrasive or solvent-based cleaner.
10
(Original instructions)
Possible solution
Check battery pack
installation.
Check battery pack
charging requirements
The switch must be
moved to "off" to prevent
the tool from immediately
starting when battery
is inserted.
Insert battery pack into
charger until LED lights.
Plug charger into a working
outlet.
Move charger and battery
pack to a surrounding
air temperature of above
45º C or below +40.5º C.
Allow battery pack to cool
down.
Place on charger
and allow to charge.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Voltage
No-load speed
Max. torque
Chuck capacity
Max Drilling capacity
/
Steel/wood masonry
Weight
Charger SFMCB11
Input Voltage
V
AC
Output Voltage
V
DC
Current A
Battery SFMCB201
Voltage 18
V
DC
Capacity Ah 1.5
Type
Li-Ion
Level of sound pressure according to EN62841:
Sound pressure (L ) 70.0 dB(A), uncertainty (K) 5 dB(A)
pA
Sound power (L ) 81.0 dB(A), uncertainty (K) 5 dB(A)
WA
Vibration total values (triax vector sum) according to EN62841:
2
Drilling into metal (a ) 1.2 m/s , uncertainty (K) 1.5 m/s
h, D
SFMCD700
V
DC
0-350/0-1500
-1
Min
Nm
mm
mm
kg
SFMCB12 SFMCB14
230 230
18 18
1.25 2
SFMCB202 SFMCB204 SFMCB206
18 18
2.0 4.0
Li-Ion Li-Ion
2
18V
50
13
13/35/13
1.2
230
18
4
18
6.0
Li-Ion