Operating; Starting Up The Machine - Schwamborn ES 51S Originalbetriebsanleitung

EN Floor Treatment Machine
ES 51S / ES 51S3 / STR 701L / STR 702S / STR 500

3 Operating

Connections with mains cables
must be protected from splash water!
Mains cables and power plugs must
undergo a functional safety check prior to
start-up!
Only suitably knowledgeable, qualified
professional electricians may perform work
on any electrical parts of the system!
When performing work on/with the machine,
watches and jewellery (e.g. rings, earrings,
chains) may not be worn!
When working on the machine (set-up,
maintenance, service, repair, cleaning, etc.), the
power supply of the machine has to be
disconnected from the mains
(Pull the power plug out of the power socket)!
Risk of poisoning due to harmful
substances at the workplace!
Eating, drinking and smoking at the
workplace is not permitted. Always eat in
break rooms or canteen areas!
After completing the work, thoroughly clean
yourself!
A general inspection of the machine must be
conducted before starting up the machine.
Particular attention should be paid to
damaged or loose components, and wear.
The machine may only be put into operation in
perfect technical condition.
Adding to or modifying the machine in any
way that could compromise operating safety
is prohibited!
Cleaning and maintenance may be done
only by trained personnel.
Maintenance must be conducted according
to the operation manual.
Do not use high pressure cleaners to clean
the machine!
Do not operate the machine in areas where
there is risk of explosion or where
flammable or hazardous materials are
present!
18
3 Operating
Risk of injury from parts flung out during
grinding!
Wear protective clothing and protective
goggles.
Wear safety shoes!
Wear safety gloves!
Proceed with the greatest care and caution!
Danger of injury from loud noise during
grinding operation of the machine!
Always wear hearing protection when the
machine is in operation!
Risk of injury from dust formation during
grinding work!
Connect an extractor unit to the machine or
feed in water during the grinding process.
Wear respiratory protection!

3.1 Starting up the machine

Observe the safety instructions in Chapter 2!
The initial start-up of the machine may be
carried out only by qualified personnel.
A visual inspection of the machine must be
carried out before starting up the machine.
Particular attention should be paid to
damaged or loose components, wearing and
filling levels!
The surface to be treated and the tools must always
be compatible with each other.
Some surfaces have to be treated when wet.