Instar IN-MOTION 500 Installationsanleitung Seite 24

Step 3: for N.C. mode, loosen the screws of V+,
V-, C and NC and insert the
black to V- and the two signal cables to NC ports.
(see fig. 3)
For N.O. mode, please connect to V+, V-, C1/T2
and NO1, as shown in fig 3.
Step 4: Tighten the screws and close the casing.
Clip the casing to the bracket
Step 5: Connect the power plug to the delivered
power supply. Connect the two signal wires to
your cameras alarm input I/O**(see fig.4)
Step 6: Test the installation height and covering
area and mount the sensor with the delivered
bracket set to your designated place. (please re-
fer to Chapter 4.3 for more installation consid-
erations)
**The I/O connector for the alarm input of your camera might look different de-
pending on your camera model. Please refer to your IP Camera user manual to
identify the correct I/O ports. You may choose either polarity when connecting the
cable (see Chapter 4.2 below).
Downloaded from www.Manualslib.com
red
manuals search engine
wire to V+, the
fig. 3
fig. 4
7
-EN
**
Camera
IO connector