Installation; Wiring Steps - Instar IN-MOTION 500 Installationsanleitung

4. Installation

4.1. Wiring Steps

Step 1: Open the IN-MOTION 500 by
using a Philips screw driver to press the
button at the bottom. Separate the front
cover from the back cover. (see fig.1)
bottom view
Downloaded from www.Manualslib.com
top view
fig.2
manuals search engine
Step 2: Use the screwdriver to knock-
out one of the two holes. Then induce
the 4 wires of the 5 meter signal cable
through this hole and proceed to next
step. (see fig.2)
6
-EN
fig.1