Inhaltsverzeichnis
Werbung
Serial ATA3 Connectors
(SATA3_0:
see p.1, No. 12)
(SATA3_1:
see p.1, No. 13)
(SATA3_2:
see p.1, No. 14)
(SATA3_3:
see p.1, No. 15)
USB 2.0 Header
(9-pin USB_3_4)
(see p.1, No. 4)
USB 3.0 Header
(19-pin USB3_7_8)
(see p.1, No. 6)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 16)
Downloaded from
www.Manualslib.com
DUMMY
USB_PWR
IntA_PA_SSRX-
IntA_PA_SSRX+
IntA_PA_SSTX-
IntA_PA_SSTX+
IntA_PA_D-
IntA_PA_D+
OUT_RET
MIC_RED
PRESENCE#
GND
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
manuals search engine
hese four SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
here is one header on
GND
GND
this motherboard. his
P+
P+
USB 2.0 header can
P-
P-
USB_PWR
support two ports.
1
Besides six USB 3.0 ports
Vbus
Vbus
Vbus
IntA_PB_SSRX-
on the I/O panel, there
IntA_PB_SSRX+
GND
is one header on this
IntA_PB_SSTX-
GND
IntA_PB_SSTX+
motherboard. his USB
GND
GND
IntA_PB_D-
3.0 header can support
IntA_PB_D+
Dummy
1
two ports.
his header is for
OUT2_L
J_SENSE
connecting audio devices
OUT2_R
to the front audio panel.
MIC2_R
MIC2_L
1
Z170M-ITX/ac
25
Werbung
Inhaltsverzeichnis
