Before Use; Wall Mounting; Using The Device - Clatronic sm 2923 Bedienungsanleitung

Scope of supply:
• Take out all the parts carefully out of the packing. Save the packing and the
inner packing material for the whole duration of the warranty.
• Clean the device before using it for the fi rst time as described in „Cleaning
and Maintenance". Caution: The blade of the bar mixer is very sharp! DAN-
GER OF INJURY!
• After use the device should be stored in the wall holder supplied.
• The mixing rod can also be attached to the wall using the attachment kit
supplied.
• In order to do this, measure the distance between the two recesses on the
back and drill two holes which are this distance apart. Make sure before you
start that you will not damage any electrical wires hidden in the walls!
• Insert the motor housing with the mixing rod into the holding device.
1. Please position the bar mixer on the motor housing in such a way that the
b dot on the mixer is located below the line I. Now turn the Bar mixer in the
direction of CLOSE until both markers b are positioned one above the other.
2. Fill the food to be mixed into the mixing bowl (max. 0.6 litres). Immerse the
mixing bar fully, but only up to the MAX mark.
3. Please hold the device in such a way that you can operate pushbutton I or
pushbutton II with your fi ngers.
Pushbutton I: This switches on the minimum speed and cannot be regulated.
Pushbutton II: This provides the maximum speed and cannot be regulated.
4. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
5. Press one of the buttons.
6. Pulsed mode is switched on by pressing the appropriate pushbutton at
intervals and then releasing it again.
7. The device switches itself off when the button is released.
8. To release the bar mixer please turn it in the opposite direction.
9. Pull out the plug from the socket after use. Clean and put the device away as
described in „Cleaning and Maintenance".
1 bar mixer with integrated blade
1 mixing vessel with lid (0.6 litres)
1 wall holder with attachment materials

Before Use

Wall Mounting

Using the Device

GB
31