Playing A Disc - Sony SCD-XB790 Bedienungsanleitung

Playing a Disc

The operations for normal play and the basic operations
during play are explained below.
POWER A OPEN/CLOSE H X
SACD/CD
1
Turn on the amplifier. Turn down the volume level
to the lowest.
2
Select the player position using the input selector
on the amplifier.
3
Press POWER to turn on the player.
4
Press A OPEN/CLOSE to open the disc tray, and
place a disc on the tray.
With the label side up
5
Press H.
Playback starts from the first track. If you want to start
playing from a specific track, turn lAMSL to
select the track number before pressing H.
6
Adjust the volume on the amplifier.
GB
14
Basic operations during play
To
Stop play
Pause play
x
Resume play after pausing
Locate a succeeding track
Locate the beginning of the
current track or a preceding
track
lAMSL
Eject the disc
z
If you turn on the player when a disc is already loaded
Playback starts automatically. If you connect a commercially
available timer, you can set it to start playing the disc at any time
you want.
z
To select a layer you want to listen to when playing a hybrid
disc (page 13)
After you stop play using x, press SACD/CD repeatedly to light
either the "SACD" or "CD."
z
To select a playback area you want to listen to when playing
a 2 channel + Multi-channel Super Audio CD (page 13)
After you stop play using x, press MULTI/2CH repeatedly to
light either the "MULTI CH" or "2 CH."
Note
During playback, increase the volume level gradually starting
from the lowest level. The output from this unit may contain band
width that are out of the normal listening range. This may cause
damage to the speakers or ears.
Press
x
X
X or H
Turn lAMSL clockwise.
When using the remote, press
>.
Turn lAMSL
counterclockwise. When using
the remote, press ..
A OPEN/CLOSE