Nowy Styl eUP Bedienungsanleitung Seite 5

1 2
First start-up / restart of the desk
To ensure correct operation, the desk needs to be started up before first use:
| Press and hold buttons "down" and "up" at the same time for more than 3 seconds until
the desk stops.
— Note: The desk will move downwards to the lowest position, then it will move upwards
by about 2 – 5 mm and then it will stop.
| When the desk has stopped, release the "down" and "up" buttons. The initial set-up process
is now completed and the desk is ready for operation.
The first start-up procedure should be performed after desk installation
or after a part of the desk has been replaced.
Desk height adjustment
To decrease desk height:
| Press and hold the "down" button until the desired height is reached.
To increase desk height:
| Press and hold the "up" button until the desired height is reached.
Saving height settings:
| Use the "up" and "down" buttons to set the desired desk height – the height will be shown
on the display.
To save multiple heights:
| Press the "S" button.
— When the display starts flashing, you have 6 seconds to press one of the buttons 1, 2 or 3
to save the current desk position to a selected number.
Comparing data from the display with the actual height
Position your desk at any height; the lowest possible position is recommended.
Measure the actual desk height and make a note of the result in centimetres or inches.
If the actual height is different from the height on the display:
| Press and hold the "S" button while also pressing and holding the "up" button, and wait
approx. 6 seconds.
— The first digit will start flashing.
| Release both buttons and press the "up" or "down" button to change the first digit.
— Increase or decrease the first digit to reach the measured value.
| Press the "S" button.
— The second digit will start flashing.
EN
eUP3
3 S
5