Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
eUP2
First start-up / restart of the desk
To ensure correct desk operation, the base needs to be started up before first use:
| Press and hold buttons "down" and "up" at the same time for more than 3 seconds
until the desk stops.
— Note: The desk will move downwards to the lowest position, then it will move
upwards by about 2-5 mm and then it will stop.
| When the desk has stopped, release the "down" and "up" buttons. The initial set-up
process is now completed and the desk is ready for operation.
The first start-up procedure should be performed after desk installation
or after a part of the desk has been replaced.
Desk height adjustment
To decrease desk height:
| Press and hold the "down" button until the desired height is reached
To increase desk height:
| Press and hold the "up" button until the desired height is reached.
4
Werbung
