Nowy Styl eUP Bedienungsanleitung Seite 6

EN
eUP3
| Press the "up" or "down" button to change digit value.
— Increase or decrease the second digit to reach the measured value.
| Press the "S" button.
— The third digit will start flashing.
| Press the "up" or "down" button to change digit value.
— Increase or decrease the third digit to reach the measured value.
| Press the "S" button. The settings have been saved.
Setting display units to centimetres or inches
| Press and hold the "S" button for 3 seconds and then press and hold the "up" button for
approx. 4 seconds.
— The height unit will be changed from CM to INCHES or vice versa.
| Release the buttons. The settings have been saved.
ADDITIONAL CONTROL PANEL FEATURES
Setting the desk to stop at a desired lowest position
(e.g. cabinet or pedestal under the desk)
| Set the desired desk height by pressing the "up" or "down" button.
| Press and hold the "S" button and then press and hold the "1" button for approx. 4 seconds
until the symbol "_L_" is shown on the display.
— The symbol "_L_" will be shown on the display. This means that the lowest desk position
has been saved.
| Release the buttons. The settings have been saved.
Setting the desk to stop at a desired highest position (e.g. window sill)
| Set the desired desk height by pressing the "up" or "down" button.
| Press and hold the "S" button and then press and hold the "3" button for approx. 6 seconds
until the symbol "_L_" is shown on the display.
— The symbol "_L_" will be shown on the display. This means that the highest desk position
has been saved.
| Release the buttons. The settings have been saved.
1. Desk height can now be adjusted within a limited range, between the preset positions.
2. Any previously saved heights beyond the maximum and minimum height positions
will be lost.
6