novaer K3 Benutzerhandbuch Seite 13

Dehumidifying Mode
•
Press the "Mode" button till the "Dehumidify" LED icon appears.
•
Automatically set the selected temperature to room temperature minus 2°C.
•
The fan speed cannot be adjusted in this mode and is automatically set to LOW
wind speed.
Note
When using the dehumidifying mode, no Hot Air Hose needs to be connected to the
unit. The dehumidifying mode is recommended for the autumn or winter season. If you plan
to use the dehumidifying mode in the summer it is recommended to add the Hot Air Hose
for discharging the hot air to the outside.
Heating Mode
•
Press the "Mode" button till the "Heat" LED icon appears.
•
Press the "▲"or" ▼"temperature button to select a desired room temperature
between 16°C and 31°C
•
Press the "Fan Speed" button to select wind speed.
Fan Mode
•
Press the "Mode" button till the "Fan" LED icon appears.
•
Press the "Fan Speed" button to select wind speed.
•
In this mode the temperature can not be adjusted.
Internal Tank Water Full Alarm Function
The inner water tank in the air-conditioner has one water level safety switches, it controls
water level. When water level reaches an anticipated height, the water full indicator lamp
lights up. (If water pump is damaged, when the water is full, please remove the rubber
blockage at the bottom of unit, and all water will drain outside.)
Continuous Drainage
•
When you plan to leave this unit unused for a long time, please remove the rubber
Page 13 of 33 V 2003