novaer K3 Benutzerhandbuch Seite 11

• (1) Turn the housing adapter and the window connector to the ends of the air hose.
• (2) Insert the fastening clip of the housing adapter into the openings on the rear of
the air conditioning system (see figure below).
• (3) Insert the other end of the air hose into the window opening.
IMPORTANT NOTICE FOR WINDOW KIT INSTALLATION
•
In order to make a hole in the glass (if required) it is advisable to bring the window
kit to the glazier as well.
•
Insert the Hose Connector (Window End) onto the Hot Air Hose.
•
Connect the other end of the Hot Air Hose with the appliance Hose Connector (Air
Conditioner End)
•
Avoid curving of the Hot Air Hose. It is recommended to be minimum 40 cm above
the ground.
•
If you do not use the air conditioner then you can close the hole with the Window
Kit.
•
Connect the power cord with the suitable electrical socket (220 – 240 V). After
inserting 2 batteries in the remote control you can either turn on the appliance
using remote control or directly by the user panel.
Page 11 of 33 V 2003