Bosch PMF 180 E Multi Originalbetriebsanleitung Seite 13

OBJ_BUCH-2236-001.book Page 13 Thursday, October 20, 2016 9:42 AM
Accessory
HM-Riff delta plate Mortar, concrete remain-
Scraper, rigid
Mounting/Replacing the Application Tool/Accessory
If required, remove an already mounted application tool/ac-
cessory.
For removing the application tool/accessory loosen the screw
9 with the hex key 10 and remove the tool.
Mount the application tool/accessory (e.g. plunge cut saw
blade 8) in such a way on the tool holder 7 that the openings
of the tool engage into the cams of the tool holder.
For a safe and fatigue-free working position it is possible to
position the application tools/accessories in any snap-in posi-
tions on the tool holder. Position the tool in such a way that
the depressed centre points downwards (marking on the tool
is readable from above, see figure on the graphics page).
Use the screw 9 to fasten the application tool/accessory.
Tightly fasten the screw 9 with the hex key 10.
 Check the tight seating of the application tool/accesso-
ry. Incorrect or not securely fastened application tools/ac-
cessories can come loose during operation and pose a haz-
ard.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding sheets are available:
Sanding disc Material
– All wooden materials
(e. g., hardwood, soft-
wood, chipboard, build-
ing board)
– Metal materials
Red quality
– Paint
– Varnish
– Filling compound
– Filler
White quality
Bosch Power Tools
Material Application
Rasping and sanding on hard surfaces;
ders, wood, abrasive ma- example: removing mortar or tile adhesive (e.g. when re-
terials placing damaged tiles), removing carpet adhesive residues
Carpets, coverings Scraping on hard surfaces;
example: removing mortar, tile adhesive, concrete and car-
pet adhesive residues
Mounting/Replacing a Sanding Sheet on the Sanding
Plate
The sanding plate 11 is fitted with Velcro backing for quick
and easy fastening of sanding sheets with Velcro adhesion.
Before attaching the sanding sheet 12, free the Velcro back-
ing of the sanding plate 11 from any debris by tapping against
it in order to enable optimum adhesion.
Position the sanding sheet 12 flush alongside one edge of the
sanding plate 11, then lay the sanding sheet onto the sanding
plate and press firmly.
To ensure optimum dust extraction, pay attention that the
punched holes in the sanding sheet match with the holes in
the sanding plate.
To remove the sanding sheet 12, grasp it at one of the tips and
pull it off from the sanding plate 11.
You can use all sanding sheets, fleece pads/polishing cloth
pads of the Delta 93 mm series of Bosch accessory program.
Sanding accessories, such as fleece pads/polishing cloth
pads, are attached to the sanding plate in the same manner.
Application
For coarse-sanding, e. g. of rough, unplaned beams
and boards
For face sanding and planing small irregularities
For finish and fine sanding of wood
For sanding off paint
For sanding primer (e. g., for removing brush dash-
es, drops of paint and paint run)
For final sanding of primers before coating
English | 13
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 40
60
medium 80
100
120
fine 180
240
320
1 609 92A 2WK | (20.10.16)